Erratum: Multi-cutter turning process stability analysis

A. M. Gouskov1 , M. A. Guskov2 , Ding Dyk Tung3 , G. Panovko4

1, 4Mechanical Engineering Research Institute of the Russian Academy of Sciences, Moscow, Russia

1, 3, 4Applied Mechanics Department, Bauman Moscow State Technical University, Moscow, Russia

2PIMM Laboratory UMR 8006, ENSAM, CNRS, CNAM, Paris, France

1Corresponding author

Vibroengineering PROCEDIA, Vol. 24, 2019, p. 89-89. https://doi.org/10.21595/vp.2019.20775
Accepted 5 May 2019; published 7 June 2019

Copyright © 2019 A. M. Gouskov, et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Creative Commons License

The description of the correction

There was an error in the author’s affiliation in the paper finally approved (after the acceptance) by the authors.

Incorrect affiliation:

1, 4Vibrations Laboratory, RAS Institute of Machine Science, St. Petersburg, Russia

Revised affiliation:

1, 4 Mechanical Engineering Research Institute of the Russian Academy of Sciences, Moscow, Russia