Vibroengineering PROCEDIA, Vol. 27

Mechanical vibrations and applications

Modeling and vibration analysis of twin-rotor system interconnected by a Hooke’s joint (Part A) Bernard Xavier Tchomeni, Alfayo Anyika Alugongo, Leonard Masu

p. 1-6 PDF

Fault diagnosis based on vibration signal analysis

Sensitivity analysis for frequency-based prediction of cracks in open cross-section beams Constantin-Ioan Barbinta, Cristian Tufisi, Codruta Oana Hamat, Dorian Nedelcu, Gilbert-Rainer Gillich

p. 7-12 PDF

Vibration generation and control

On the combination of topology optimization and multiple mass dampers Christian Brecher, Guifeng Zhao, Marcel Fey	p. 13-18 PDF
Design study of a magnetoelectric-electromagnetic vibration energy converter for energy harvesting Sonia Bradai, Slim Naifar, Olfa Kanoun	p. 19-23 PDF

Seismic engineering and applications

Study on the dynamic characteristics of solidified silt under dynamic load Shuo Jiang	p. 24-29 PDF
Earthquake damage on the vaulted nave of the Atlatlahucan Ex-Convent church in Morelos, Mexico Guillermo Martinez, Jose M. Jara, Bertha A. Olmos	p. 30-36 PDF

Modal analysis and applications

A versatile algorithm for estimating natural frequencies with high accuracy Gilbert-Rainer Gillich, Dorian Nedelcu, Constantin-Ioan Barbinta, Nicoleta Gillich

p. 37-42 PDF

Vibration in transportation engineering

Optimum suspension design for non-linear half vehicle model using particle swarm optimization (PSO) algorithm Ahmet Yildiz	p. 43-48 PDF
The effect of system improvement on regulation of pressure inside pneumatic spring element and on transmission of acceleration Tien Tran Xuan, David Cirkl	p. 49-54 PDF
Editor's Pick Concept for an event-triggered wireless sensor network for vibration-based diagnosis in trams Maik Wolf, Mathias Rudolph, Olfa Kanoun	p. 55-60 PDF

Flow induced structural vibrations

Numerical analysis of a vertical rotor rub system partially immersed in inviscid incompressible fluid Desejo Filipeson Sozinando, Bernard Xavier Tchomeni, Alfayo Anyika Alugongo

p. 61-66 PDF

Biomechanics and biomedical engineering

Fracture strength estimation of L3-L4 intervertebral disc using FEA Raj Arjun S I, Chandrashekara C V, Parth Goplani	p. 67-72 PDF
Cell dynamics and natural frequencies: scaling and shape matters Chandrashekara C V, Ayman Ahmed Mubeen, Arun Barathwaj R, Amith Basavaraju, M C Srividyadhare Kateel	p. 73-77 PDF
Dynamics of osteoblasts during bone remodeling cycle Chandrashekara C V, Shrishti Chaudhary, Shivcharan M, Avinash Ramachandran, Raj Arjun S I	p. 78-82 PDF

Dynamics and oscillations in electrical and electronics engineering

Simulation of elastic wave transmission in phononic crystal waveguides Yunfeng Gu

p. 83-87 PDF

Materials and measurements in engineering

Impact of selected sources of transport vibrations on the perception of vibrations by people in buildings Alicja Kowalska-Koczwara	p. 88-92 PDF
Transmission of vibrations from the ground to the foundation from the movement of passenger trains Filip Pachla	p. 93-96 PDF

Mathematical models in engineering

Experimental setup for unbalance fault detection and vibration analysis in a cardan shaft (Part B) Bernard Xavier Tchomeni, Alfayo Anyika Alugongo, Leonard Masu	p. 97-102 PDF
Radiation damping for rigid foundations. Approximate expressions Bertha Olmos, José Manuel Jara, Guillermo Martínez	p. 103-108 PDF
Effects of mechanical non-linearity on the dynamic behaviour of ring-based inertial rate sensors Violetta Di Napoli, Stewart McWilliam, Atanas A. Popov	p. 109-114 PDF
The effect of using shell and solid models in structural stress analysis Gürkan İrsel	p. 115-120 PDF
Modelling of pressure-temperature conditions for cavitation initiation in different liquids N. Mikhailova, I. Smirnov, G. Volkov	p. 121-125 PDF

System dynamics in manufacturing system modeling

Study on compressing principle of the fresh municipal solid waste Yongneng Lu, Erfei Zhao, Zhenping Zhou, Mingwei Wang	p. 126-132 PDF
The influence of ferromagnetic fluids on performance of hydrodynamic bearings Jaroslav Zapoměl, Petr Ferfecki	p. 133-138 PDF
An extrusion simulation of an aluminum profile by porthole die Önder Ayer, Sedat Bingöl, İsmail Karakaya	p. 139-144 PDF

Dynamics of Smart and functionally graded materials

Dynamic characterization and modeling of steel foam sandwich structure Sasan Farhadi, Shervin Ziadloo

p. 145-149 PDF