Journal of Vibroengineering, Vol. 16, Issue 3

May 2014, Pages (1106-1618), ISSN Print 1392-8716, ISSN Online 2538-8460

Cover and Contents Browse Journal Articles in Press Current Issue 2020 - Vol. 22, Issue 6 2020 - Vol. 22, Issue 5 2020 - Vol. 22, Issue 4 2020 - Vol. 22, Issue 3 2020 - Vol. 22, Issue 2

JVE Conferences

49th JVE Conference in Almaty, Kazakhstan

"Electrical Engineering and Communication Electronics" November 26-28, 2020 in Almaty, Kazakhstan

50th JVE Conference in Dubai, United Arab Emirates

"Vibration and Acoustics in Civil Engineering and Fault Diagnostics" March 25-27, 2021 in Dubai, United Arab Emirates

"Dynamics, Noise and Vibration Engineering: Problems and Applications" May 7-8, 2021 in Dublin, Ireland

52nd JVE Conference in St. Petersburg, Russia

"Nonlinear Dynamics and Chaos in Engineering Applications" June 28-30, 2021 in St. Petersburg, Russia

www.jveconferences.com

Design considerations of a MEMS cantilever beam switch for pull-in under electrostatic force generated by means of vibrations Serhat İkizoğlu, Ayşe Özgül Ertanır	p. 1106-1113 PDF
Investigation on soft landing impact test of scale lunar lander model Qing Lin, Zhiyu Kang, Jie Ren, Qilong Zhao, Hong Nie	p. 1114-1139 PDF
Self-synchronization theory of a nonlinear vibration system driven by two exciters. Part 2: Numeric analysis and experimental verification Li Ye, Li He, Wei Xiaopeng, Wen Bangchun	p. 1140-1150 PDF
Hysteresis behavior of reinforced concrete bridge piers considering strength and stiffness degradation and pinching effect Qiang Han, Huihui Dong, Xiuli Du, Dezhang Sun, Chao Huang	p. 1151-1161 PDF
Seismic test and numerical verification of the scaled-down reinforced concrete containment vessel Yu-Chih Chen, Wei-Ting Lin, Tung-Liang Chu, Yuan-Chieh Wu	p. 1162-1167 PDF
Study on the extraction method of transverse open crack’s information Yang Liu, Qin-Liang Li, Hong-Liang Yao, Bang-Chun Wen	p. 1168-1178 PDF
Analytical solution for dynamic response of segment lining subjected to explosive loads Yang Liu, Mingyang Wang, Derong Wang	p. 1179-1187 PDF
The finite element modeling and stability prediction of high-speed spindle system dynamics with spindle-holder-tool joints Bo Wang, Wei Sun, Kunpeng Xu, Junyong Zhang, Bangchun Wen	p. 1188-1199 PDF
A bearing fault detection method based on compressive measurements of vibration signal Xinpeng Zhang, Niaoqing Hu, Guojun Qin, Zhe Cheng, Hua Zhong	p. 1200-1211 PDF
Validation of bucket wheel drive component model through vibration monitoring: a torque arm key study Vesna Damnjanović, Predrag Jovančić	p. 1212-1218 PDF
Modal parameters identification based on noise reduction for jacket type offshore platforms Xingxian Bao	p. 1219-1230 PDF
Structural nonlinear vibration reliability analysis based on improved ant colony algorithm Yancang Li, Chenguang Ban, Shujing Zhou, Qiuyue Cheng, Shuanghong Peng	p. 1231-1239 PDF
Stochastic bifurcation characteristics of cantilevered piezoelectric energy harvester Jia Xu, Ming-Yi Luan, Zhi-Wen Zhu, Kang-Kang Guo	p. 1240-1247 PDF
Investigation of stresses during dynamic behavior of polymeric films used for Braille I. Venytė, E. Kibirkštis, A. Voloshin, K. Ragulskis, P. Paškevičius, A. Sudintas, L. Ragulskis	p. 1248-1257 PDF
Sensorless speed control of a vector controlled three-phase induction motor drive by using MRAS Ali Saffet Altay, Mehmet Emin Tacer, Ahmet Faik Mergen	p. 1258-1267 PDF
Peak cycle stress analysis of plain dent on pipeline based on FE calculation Ying Wu, Wu Liu, Huawen Wu, Peng Zhang	p. 1268-1275 PDF
Theoretical analysis on thermally induced vibration of tapered parallelogram plate with mixed boundary conditions Anupam Khanna, Pratibha Arora	p. 1276-1283 PDF
Dynamic stress response and fatigue life of cantilever beam under non-Gaussian base excitation Junyong Tao, Hongwei Cheng	p. 1284-1296 PDF
Relation between reduction of weighted impact sound pressure level and shape of small size specimen of floating floor construction Vidmantas Dikavičius, Kęstutis Miškinis, Karolis Banionis, Edmundas Monstvilas	p. 1297-1305 PDF
Antiseismic response research of horizontal residual heat removal pump in different seismic spectrum input directions Xin Deng, Shouqi Yuan, Jianping Yuan, Qiaorui Si, Yalin Li, Yuwen Zhu	p. 1306-1317 PDF
A novel semi-active suspension design based on decoupling skyhook control Jialing Yao, Saied Taheri, Songmei Tian, Zhongnan Zhang, Liang Shen	p. 1318-1325 PDF
Efficiency improvement of energy harvester at higher frequencies Giedrius Janusas, Ieva Milasauskaite, Vytautas Ostasevicius, Rolanas Dauksevicius	p. 1326-1333 PDF
Investigation of clamping force for a high-speed shaft with toolholder using contact element analysis Shin-Yong Chen, I-Feng Lin	p. 1334-1342 PDF
Investigation of tactile characteristics of the piezoelectric bimorph type actuators R. Bansevičius, V. Jūrėnas, M. Gudauskis, A. Žvironas	p. 1343-1348 PDF
Assessment of the vibroactivity level of SI engines in stationary and non-stationary operating conditions Figlus Tomasz, Liščák Štefan	p. 1349-1359 PDF
Proposing an optimal integral-based intensity measure for seismic collapse capacity assessment of structures under pulse-like near-fault ground motions Masood Yakhchalian, Ahmad Nicknam, Gholamreza Ghodrati Amiri	p. 1360-1375 PDF
Applying b-value variation to seismic hazard analysis using closed-form joint probability distribution Ahmad Nicknam, Mostafa Khanzadi, Sasan Motaghed, Azad Yazdani	p. 1376-1386 PDF
Bearing performance degradation assessment and prediction based on EMD and PCA-SOM Chen Lu, Hang Yuan, Youning Tang	p. 1387-1396 PDF
Investigation of air-coupled generation of asymmetric Lamb waves using rectangular phased arrays Almantas Vilpišauskas, Rymantas Kažys	p. 1397-1404 PDF
Development of large salient-pole synchronous machines by using fractional-slot concentrated windings Tayfun Gundogdu, Guven Komurgoz	p. 1405-1415 PDF
Reduction of axis acceleration of quarter car suspension using pneumatic actuator and active force control technique P. Sathishkumar, J. Jancirani, John Dennie	p. 1416-1423 PDF
An approach for tool health assessment using the Mahalanobis-Taguchi system based on WPT-AR Chen Lu, Yujie Cheng, Zhipeng Wang, Jikun Bei	p. 1424-1433 PDF
The defect detection in glass materials by using discrete wavelet packet transform and artificial neural network Gokhan Gokmen	p. 1434-1443 PDF
An approach to performance assessment and fault diagnosis for hydraulic pumps Bei Jikun, Lu Chen, Wang Zhipeng, Wang Zili	p. 1444-1454 PDF
Deformation-compensated modeling of flexible material processing based on T-S fuzzy neural network and fuzzy clustering Yaohua Deng, Sicheng Chen, Jiayuan Chen, Jiayi Wu, Qiaofen Zhang, Liming Wu, Hui Chen	p. 1455-1463 PDF
Health assessment and fault diagnosis for centrifugal pumps using Softmax regression Jian Ma, Chen Lu, Wenjin Zhang, Youning Tang	p. 1464-1474 PDF
Influence of imbalance force angular position to vertical and horizontal rotors rolling bearings defects diagnostics Artūras Tadžijevas, Vytautas Barzdaitis, Pranas Mažeika, Marius Vasylius	p. 1475-1482 PDF
Flutter analysis for wing structure using finite element modeling with equivalent stiffness Xing Ouyang, Xiongqing Yu, Yu Wang	p. 1483-1493 PDF
A new nonlinear longitudinal vibration model of belt driving system applied in energy saving Mingming Xing, Shimin Dong	p. 1494-1509 PDF
Fracture toughness prediction of eutectic ceramic composite considering damage effect and transformation toughening Xinhua Ni, Cheng Chen, Shuqin Zhang	p. 1510-1522 PDF
Human activity recognition: classifier performance evaluation on multiple datasets Pavel Dohnálek, Petr Gajdoš, Tomáš Peterek	p. 1523-1534 PDF
Development of vibrating bracelet for the actuation of the blood circulation at capillaries M. Venslauskas, V. Ostasevičius, V. Jūrėnas	p. 1535-1542 PDF
Vibrations of a plate on a two-parameter foundation subjected to moving rectangular loads of varying velocities Zheng Lu, Hailin Yao, Yongxiang Zhan, Zhi Hu	p. 1543-1554 PDF
Simulation of the lateral oscillation of rope-guided conveyance based on fluid-structure interaction Renyuan Wu, Zhencai Zhu, Guoan Chen, Guohua Cao, Wei Li	p. 1555-1563 PDF
Identification of second-order kernels in aerodynamics Yunhai Wang, Jinglong Han, Zhang Bin	p. 1564-1573 PDF
A well-balanced unsplit finite volume model with geometric flexibility Byunghyun Kim, Taehyung Kim, Jinho Kim, Kunyeon Han	p. 1574-1589 PDF
Combination resonances of parametric vibration system of the field modulated magnetic gear Xiuhong Hao, Xiaoming Yuan, Hongfei Zhang, Lijie Zhang	p. 1590-1601 PDF
Application of Butterworth filter for fault diagnosis on journal bearing T. Narendiranath Babu, T. Manvel Raj, T. Lakshmanan	p. 1602-1617 PDF
JVE International Conferences 2014	p. 1618-1618 PDF