Published: 10 December 2020

Erratum: Mathematical modeling of the solution to the problem of plate bending given various fastenings along the contour and various loads

Serikbay Toibayev1
Assemgul Uderbayeva2
Zhanar Bidakhmet3
Ayaulym Rakhmatulina4
Algazy Zhauyt5
1, 2, 4Department of Engineering Graphics and Applied Mechanics, Almaty Technological University, Almaty, 050012, Kazakhstan
3Department of Mathematical and Computer Modeling, Faculty of Mechanics and Mathematics, Al-Farabi Kazakh National University, Almaty City, 050040, Kazakhstan
5Department of Electronics and Robotic, Almaty University of Power Engineering and Telecommunications, Almaty, 050013, Kazakhstan
Corresponding Author:
Serikbay Toibayev
Views 30
Reads 10
Downloads 734

The description of the correction

The institutional affiliation was incorrect for Bidakhmet Zhanar in the paper finally approved (after the acceptance) by the authors.

Incorrect institutional affiliations:

1, 2, 3, 4Department of Engineering Graphics and Applied Mechanics, Almaty Technological University, Almaty, 050012, Kazakhstan

5Department of Electronics and Robotic, Almaty University of Power Engineering and Telecommunications, Almaty, 050013, Kazakhstan

Revised institutional affiliations:

1, 2, 4Department of Engineering Graphics and Applied Mechanics, Almaty Technological University, Almaty, 050012, Kazakhstan

3Department of Mathematical and Computer Modeling, Faculty of Mechanics and Mathematics, Al-Farabi Kazakh National University, Almaty City, 050040, Kazakhstan

5Department of Electronics and Robotic, Almaty University of Power Engineering and Telecommunications, Almaty, 050013, Kazakhstan

About this article

Received
09 December 2020
Accepted
09 December 2020
Published
10 December 2020
Source