Published: 30 June 2011

Active control of the process and results of treatment

V. Gichan1
Views 0
Reads 0
Downloads 995

Abstract

The article analyzes the problems associated with the measurement and control of process parameters and the parameters of the work piece. Stabilization force parameters, of acceptable quality requires a regulator with variable structure and high precision of their measurement. Analysis of the frequency change in the power of idling can detect defects in the kinematics. Rate of change of load can determine the dynamic parameters of the cutting process. When handling gears stabilize the load can be performed by a pulsed method

About this article

Received
10 March 2011
Accepted
27 May 2011
Published
30 June 2011
Keywords
cycle of grinding
regulator with variable structure
power measurement
dynamic parameters
kinematic delay